Got the converter back and installed last Thursday. Put it through its paces and its all good now. In fact, it’s running smoother than it has the whole time I’ve owned it! Took it to the Gilmore muscle car show in MI on Saturday without issue. Had a good time and it’s a real treat to drive now.
Great question.
I noticed a vibration at interstate speeds before it broke that day. Could be bearings, or a fifty year old converter that just gave up.
I’m hoping to get some advice on where to source a replacement converter. My usual parts places like Summit, etc only seem to carry...
Update
I ended up opting to have the trans rebuilt and decided I might as well upgrade some internals at the same time since I aim to increase power later. I managed to get CRT to do the work and he got it back more quickly than expected, which was appreciated.
Yesterday I was able to get it...
Managed to yank the trans last weekend. Tiny garage be damned!
No obvious damage to the front seal or tc, but it can’t be leaking from too many places. If I change the seals myself is there anything I need to watch out for? Or am I better off tossing it at a shop?
Swapping in a 500 would be...
Idk how I missed this. Late reply, I know….
489 case.
I like the 3.23s with the a904 I have now. Maybe I’ll swap to a a500 someday and want taller with the additional gear.
The sure trac is niiiiiice. No regrets there.
There’s just a tiny bit of “howl” after the gears get warmed up. Not sure if...
Pulled the '72 Barracuda out of storage, got it 3/4 way home before seeing smoke rolling out the back. Limped it home to find tranny fluid puking out the front of the 904's bel housing, spraying all under the bottom, and coating the exhaust. I'm guessing the front seal failed. Not the start to...
Is this rear sway bar original, or aftermarket? 72 Barracuda.
I ask because the original brake lines (removed) don’t really have notches around the U bolts.
Thanks for the confirmation.
I suppose I will reinstall only one on each side and see where that gets me. I still can't figure out why there was two--I never had any issues--but if I have any trouble with end-play adjustment I can always add them back.
Yes 8 3/4.
The pdf doesn’t show the location of the backing plate.
Also, I should have mentioned there was also a white “gasket” between the backing plate and the bearing housing.
Working to reassemble axles after a gear change. During disassembly found two axle gaskets stacked between the backing plate and the axle flange on each side, for a total of four. These are the metal/rubber gaskets.
Does anyone know if two stacked is “correct”? Any thoughts as to why double...
Well, Unfortunately Carlisle isn't going to work out for me this year. If you happen to find yourself in the vicinity of Indiana, hit me up. Enjoy your trip!