Does anyone have any idea what these would be used for there are 5 of them?

[Flathead31coupe]

They look like they would go inside of a rubber piece of some sort.There are tiny..

 

[AUSTA]

They look like the washers that hold the speedo in usually have a rubber washer on it to stop vibration

 

[EV2RTSE]

They look like they might be part of the mounts for a rear defogger motor and yes there would be rubber washers in between, there would be 6 of them though.

 

[Chryco Psycho]

or the wiper motor

 

[Miguel Duncan]

They also go on the three studs to hold the heater, A/C fan motor flange onto the firewall. The rubber isolation gasket has a molded raised "pad" that these conical washers compress by the nut. I'm the original owner, so know this is factory correct.

 

[Flathead31coupe]

Thanks everyone when I get further along on putting it together.I'll be able to check these things out....

 

[Flathead31coupe]

They also go on the three studs to hold the heater, A/C fan motor flange onto the firewall. The rubber isolation gasket has a molded raised "pad" that these conical washers compress by the nut. I'm the original owner, so know this is factory correct.

View attachment 145820

Since there are 6 of them, do you think one goes on each side?\nOf the rubber thanks

 

[Miguel Duncan]

I didn't thinks so at first, but then referenced this picture I took when refurbishing my Heater Box (used outstanding Detroit Muscle kit - - seen in the sidebar). It clearly shows two conical washers per stud. So your question was a good one! Mystery solved

 

[Flathead31coupe]

I didn't thinks so at first, but then referenced this picture I took when refurbishing my Heater Box (used outstanding Detroit Muscle kit - - seen in the sidebar). It clearly shows two conical washers per stud. So your question was a good one! Mystery solved

View attachment 145855

Thanks....