My Challenger is a factory 3:55 and I installed a 3:23 . The difference is small but noticeable on highway runs especially the longer hauls. Either gear is a great choice. The 3:23 is behind a 440 , with the torque of the big block a 3:23 still spins those 275/60/15’s .
PG Classics I think are who you refer to in New Brunswick. PG Classics are now in Ottawa Ont Can. Yes, I do believe they sell the caps and much more in Canada but the prices are in USD
Would you have a picture and or measurements? I picked up a grade 8 bolt and a nylock nut. It seems to be fine, should work, but I would rather have an original part...
Hi,
I am looking for 70 Challenger L+R headlight bucket to Radiator cradle brackets as well as the small grill to headlight brackets L+R as in the attached picture. circled in Black.
One or Two, all, whatever you may have.
Appreciated!
RJH..
I looked again at the linkage, yes you are correct, the spacer is part of the lever system, bushings as well installed. For some reason I am missing this bolt, the troubles with inheriting someone else project. Thank you for the picture, I now know what it looks like! I can search or...
Hi,
My 70 Challenger was disassembled by the previous owner.
The power brake linkage under the dash, I am missing the long bolt and spacer for the lower linkage mount.
What can be used in its place or is this bolt specific for this application?
Anyone have one for sale? In the attached...
Ok,,the buckles look good. You only have the two buckles? Damn, I need 4. I may let the post go a bit longer and see if four buckles pop up if you dont mind? These are the buckles I am looking for. The webbing really doesn't matter to me all that much.
Hi,
I am looking for the front inner seat belts (female side) that bolt to the trans hump 70 Challenger with buckets. I would take a beat up set as long as the buckles are in good shape. Just 4 buckles is ok as well, Black preferred.
When I bought my 70 Challenger the front inner belts...
Hi,
Yes, I will be using the 5/16 ribbon as I am re-installing the original glass.
I read in another forum regarding the glass thickness and ribbon seal thickness. It does make sense if the glass is thinner. When I look at the glass I think it is quite thin already, not sure it could get any...
Grady Cain
After going out to the car and taking a good look I think you likely are correct having the Blue side of the clip down. If installed the other way the finish molding may not fit. I will install them as you describe unless something else shows me there is another way?
Thanks again...