Search results for query: *

If you use Perronix , make sure the Dist has 13v at all times , , the coil feed drops to 7v when running & the unit Will fail quickly

I agree , Chev intake , the carbs are missing a lot of parts , the list # are on the back behind the airhorn on the front & back carbs ., in front on the middle carb They are vacuum operated carbs so there should be vacuum pots on the right side of the carbs , { left in your pix ] to pull the...

MY bet is timing is retarded too much , should be 16-18* at idle rising to 36* Next the electric fan is probably block more air than it is moving , Factory used a clutch fan , it tightened up at low RPM to move air but released with RPM & temp to allow full air flow at highway speeds , if the...

Pull the plug & send Mn to the bottom of the ocean

Overall the factory system is very reliable , carry an extra ballast resistor of course & use a good quality 4 pin ECU , parts are readily available unlike aftermarket systems

Love the color !

Welcome , Nice 70 !

Welcome to the site !

Welcome to the site my friend had one identical a decade ago .

Nice ! i love the blue Mini too !

Welcome !

I don't recall there being a difference in the lens in 70 . Welcome BTW

Welcome to the site !

Welcome , Nice Ride !

If it has been replaced & it is difficult to tell you probably have a far better grille than 55 year old brittle plastic

Welcome Dave , if it is an original 360 Chall they are quite rare / low production

My condolences .

I have often seen this , was it factory , Dunno

Ok I was wrong , not made in China but still not made with decent quality or materials Most I have seen , heads & intakes etc have bad core shift . 1 customer bought a carb where the fuel bowl wall was not cast so the counterweight for the air door was sitting in fuel , it had a quality...

Nice , Welcome !