Search results for query: *

Ordered! Seems to be a common problems, saw the same thing on A bodies thread. Thanks.

Was having a new sending unit installed on my 1971 Challenger and we could not get a tight seal on either the old gasket or new gasket? Any ideas on how to seal this?

Did work before with the conventional points

Mopar Electronic ignition and original tach. It is a Rally dash also.

Had the old point distributor in and install the new electronic ignition. I cannot get the tach to work. Any suggestions for troubleshooting?

I have a set of white convertible interior panels that would like to have dyed black. I am here in the Chicago area. Any ideas?

If I wanted sarcasm I'd watch Jimmy Kimmel. Going with longer studs and a spacer is a more economical solution than spending $$$ for a disk brake set up. This was a situation that neither my tire guy nor I anticipated. He even came to my home to see the issue.

Thanks for the info, I called Dorman today and they gave me a Ford stud that may work. Going to get one right now.

I have no problem with a spacer, but I need longer studs to bolt the wheel to.

I didn't think it would be a problem either. These are 15 inch rims. The stock 14 inch rim was indented to fit into the drum.

I have a 1971 convertible with the stock drum brakes in the front. I went to mount my new Cragar S/S mags on the front and because of the large fins on the drum the rim will not mount flush to the drum. I can put a 1/2 spacer in to shim out the drum but am having trouble finding replacement...

I have the front and rear bumpers from my 71 Challenger. They would need to be rechromed as I bought new ones. Where are you located? PM me.

So what you are saying is that an aluminum 3 core should be enough to keep this motor cool? I want to stay with the 22 inch. Should I get the electric fans also. I know a shroud is important too!

In my 1971 Challenger convertible, it was a stock 318 with a 3 speed. I have now gone to a 340, mild rebuild and was looking to put a 4 core 26 inch radiator in for maximum cooling, but it seems the mounting plate will only accommodate a 21 inch. Were there 2 different radiator mounts put in...

pm me your email address and I will send them to you

I the next day or so, I have to move stuff around in my shed

I have a pair out of a 73 Challenger, need new foam and covers, no rails.

Thanks for the insight, will pull it off this winter and have the bottom machined flat.

Should I be able to pick that o ring up from a local parts house. And yes it is an aftermarket chrome neck.

I have just put together my 1971 Challenger with a mildly built 340. I replaced the old radiator cap with a new 16lb cap. I am having trouble getting the neck to seal to the intake manifold. I used a quality sealer and gasket but when the system pressurizes, it leaks through the gasket and up...