Search results for query: *

Ok ty.

I found this may help explain it lol... four a seventy three barracuda...

Is the 73 barracuda body wiring different than the challenger wiring....

This is the wiring diagram I was talking about.If you look at the driver's side door sweat

I will check into that since its in the harness with just the yellow wire going to the door switch. Unless there's another wire that comes down from the dash it really has no length to go anywhere other than close by the door switch. I did find another schematic that showed the passenger side...

So far I have windshield wipers amp gauge oil gauge... And heater fan motor I don't have any of the upper light bar lights.in the dash I did check in before I put it in the dash... Also , no console light bulb is good.

Thanks again.Whatever that black spade wire goes to on the driver's side, it's in the same harness as the yellow wire that goes to the door switch.There's only two wires there , and it has twelve volts on it

L o l sent you are on a roll.. Any clue where this double black spade clip , wire goes.. Also , there is a black spade wire on the driver's side where the door light switch is not sure where it plugs in at or if it's missing a clip of some sort two plug for ground , thanks

So i've got 12v on the red on both sides of the plug.. And only 6.5v on the brown wire coming from the plug with the key in the position.. so the Brown wire gets its power through the Ignition switch Correct?Possible ignition switch issues

I have 6.5v coming from slot 22 the brn wire from the firewall to the ballast. I have 12.65 at the battery.. And I have the same volts on the red wire.. Going to the ignition switch .. But only have 11.5 on the fuses.. When I touched the positive cable to the battery with the key on or the off i...

Ok thanks alot

So after a little bit of time, I finally got the new wine harness installed new ballast resistor new starter relay. And came the grand moment to start when I tried it , it lit off as i'm holding the key in the start position stopped when I let up.. I'm sure it's been discussed a lot of times...

Thank you...

I have a new neutral safety switch wiring harness that goes from the bulkhead down to the transmission. My question is, there is a white plastic hanger that is made into the harness. It looks like it hangs on something.I am looking to find out where that wiring harness hangs at on the firewall...

Wow thank you.. That could not have been a more perfect answer to my questions....

I am looking for the proper hose routing. For the spark thing on the passenger side firewall.. As well as the routing for the hoses from the fuel canister.\nTo the carburetor.. Also, the vacuum temperature switch on the radiator has 2 hoses not sure where they go or how they are routed.Any help...

Looking for factory headlight wiring harness mounting tabs that go along the inside of the radiator core support and on each side.. I believe they are bendable with a rubber coated tip.. Maybe from a used core support in here, they can be drilled out on\nThe spot welds i believe...

Ok thanks