Search results for query: *

Thank you..

I am looking for a diagram that shows where the Springs and the orientation of the kick down lever attaches to the carburetor..thanks

As always, once again, thank you.Seems that my dimmer switch on the dash needs cleaned... i Was able to file a couple of flat areas to get it working.\nA new one will be in order...

You are correct.I have no power there with the key on or off

It looks like the dark blue wire that comes from the Ignition switch feeds 12 V to the number five fuse , which I do not have voltage at..

Here's one for you.I have no power on number 5 on the fuse box which I believe does.My dash lighting trying to figure out the main wire where it gets the power from.. Sometimes it makes your head hurt.Looking at all those wiring schematics , l o l

Ok ty.

I found this may help explain it lol... four a seventy three barracuda...

Is the 73 barracuda body wiring different than the challenger wiring....

This is the wiring diagram I was talking about.If you look at the driver's side door sweat

I will check into that since its in the harness with just the yellow wire going to the door switch. Unless there's another wire that comes down from the dash it really has no length to go anywhere other than close by the door switch. I did find another schematic that showed the passenger side...

So far I have windshield wipers amp gauge oil gauge... And heater fan motor I don't have any of the upper light bar lights.in the dash I did check in before I put it in the dash... Also , no console light bulb is good.

Thanks again.Whatever that black spade wire goes to on the driver's side, it's in the same harness as the yellow wire that goes to the door switch.There's only two wires there , and it has twelve volts on it

L o l sent you are on a roll.. Any clue where this double black spade clip , wire goes.. Also , there is a black spade wire on the driver's side where the door light switch is not sure where it plugs in at or if it's missing a clip of some sort two plug for ground , thanks

So i've got 12v on the red on both sides of the plug.. And only 6.5v on the brown wire coming from the plug with the key in the position.. so the Brown wire gets its power through the Ignition switch Correct?Possible ignition switch issues

I have 6.5v coming from slot 22 the brn wire from the firewall to the ballast. I have 12.65 at the battery.. And I have the same volts on the red wire.. Going to the ignition switch .. But only have 11.5 on the fuses.. When I touched the positive cable to the battery with the key on or the off i...

Ok thanks alot

So after a little bit of time, I finally got the new wine harness installed new ballast resistor new starter relay. And came the grand moment to start when I tried it , it lit off as i'm holding the key in the start position stopped when I let up.. I'm sure it's been discussed a lot of times...