Search results for query: *

Thanks guys I’ll try Stephen’s performance to see if they have the linkage.

I have a 71 challenger that was a manual drum brake car, I am converting to power disc and have installed a 9” booster. All good but as expected the original pedal and linkage does not work. What are my best options? Can I buy a power brake pedal, then what else do I need? If I keep the...

Thanks Guys Challenger RTA, your list is right on target. Yep, I called Blake from Sublime technologies, he walked me through the wiring, which was connected correctly. Only like 5 wires needed to get it running so I’m glad I didn’t screw that up. He a gave me a quick troubleshooting check...

Hi Plum_72 I am using sublime technology quick start system with stock engine harness, I do have the Sound German connected to ground and power when trying to test start. Cranks and fires up but dies right away.

Hi All Looking for thoughts and suggestions I have a 2020 6.4 w/ 8hp70, Sublime quick start set up with stock engine harness. I connect the battery power to engine harness, grounds are all connected, I connect ignition to power, then connect key on which cycles the throttle body and fuel...

What mounts are you guys using? I am using the Holley mounts (long story). With these mounts I had to notch the drivers mount to get the TTI headers to fit, the add 3/8 spacer to the mount to raise the engine a bit to get the headers to clear the stock steering box. Switching to the Bergman...

Today was the first start up of my 2020 challenger 392 engine in my 71 challenger body. I had changed out the valve in the ps pump to reduce the pressure, but on first start up it dumped fluid all over the place. Lost half a quart in 20 seconds of run time, seems to have come out of the top...

I am looking for the Passenger side slider Thanks

This car is still a work in progress so the lights are not all adjusted yet for final assembly. There was no cutting the actual width of the 2024 tail lights. They come in 3 separate sections and when put together the width is near perfect fit on 70 - 74 challenger. The headlights were a...

Actually once I cut out the rusty tail panel and trimmed it to fit, it kind of fit right into place. I did fabricate the backing plate to bolt it in. Was easier than you might think

Since we’re getting sideways Here is my solution Grafted in a 2024 tail light

Buying this one, thanks Sal

Hi All, I’m needing a passenger door latch (bolts inside pass door) preferably with the rod to the key lock mine is binding up and don’t want to spend a weekend trying to get it working. Life short, so if you have one that works smooth, please PM me Thanks Jay

Hi All Looking for the following door glass hardware for 71 challenger 1. Screw that holds the front slider in place. See pic 1 2 entire rear slider, slides inside track and bolts to rear of glass, pic 2 3 bolts and hardware that holds the horizontal slide to door glass, pic 3 Please pm me...

Now just looking for the primary latch, the one that bolts to the radiator support

Replied PM

Looking for both primary hood latch and secondary hood release. Driver condition that can be cleaned up is fine. Already bought cheap aftermarket knock off, complete trash Please pm me with what you have Thanks Jay

Thanks guys, I got her plumbed up as shown on the diagram. Hoping for first start up in a coupe weeks

Thanks guys So the existing hose in the photo I posted connects the ports at the back of the engine to a port at the front of the engine, does that stay connected as in the photo I posted? What pushes the circulation when only using the back 2 ports on the engine ?

Hi All I’m doing a 6.4 Hemi swap into a 71 Challenger convertible. I am having difficulty understanding how to run the heater hoses. I have 2 ports at the rear of the engine under intake manifold. The engine came with a hose that seems to connect them with a port at the top of the engine, see...