Search results for query: *

Ate a valve head

I was starting my 72 Barracuda 318 from cold, when I heard a bit of rattling (like a spring came loose) Then I noticed it was running very rough and would not idle. I pulled all the spark plugs and noticed one of them is rather damaged... Photos attached.

Clockwise or counter clockwise?? Open or closed? I want to wire it open, is it counter clockwise CLOSED and clockwise OPEN? thanks

Ok so I unplugged the sender, put some cable in the plug and put the other end of the cable onto the frame of the car. Nothing happened. When I plug the sender back in the gauge goes up a little. I don't think there is a problem with the gauge.

Gets to about 32 at the lowest maybe a little lower. I am not really keen on taking off the manifold to take out the plate.. would rather wire it open or tack weld it open, not sure if the cast iron will take to the weld though.

Hi guys, My fuel gauge as topic states, seems to work , but when full doesn't show full and as I use fuel it moves a little down. Is there a problem with the fuel sender or the gauge, I would have thought that the gauge is working as it moves a little. thanks jc

I have a 72 Barracuda 318. The heat riser on the exhaust manifold has consistent rattling, I am under the understanding that it should go away once the engine heats up to optimum. Mine seems to keep going, its rather embarrassing. I heard you can weld/tap it open or you can remove the riser...

thanks Leo, I contacted the seller and he issued a refund, obviously he gets a few faulty. I could salvage the cancel cam off the new switch and the lights are all working fine apart from when right signal is engaged and brake is depressed... the brake light on left will not come on. I think the...

Okay guys, Ordered a complete new signal switch from the states after the signal cam was faulty, should have learnt and not gone to the same ebay shop. Anyway. installed the new switch and as soon as I plug into factory loom/plug (had to modify female plug to accommodate new cheap chinese plug)...

I checked the signal cam and the it seems a little tab of plastic had broken off. so the contact wasn't in place. Would this be the reason for brake light failure? see photo

72 barracuda rear right brake not working, rear right hazard not working but... Rear right signal is working. All the same globe but different filament. I replaced signal cam.. Is this the problem? Swapped out globe/bulbs no fix.

Leo, the choke could well be the problem. where is it? I will have to look in the workshop manual. I'm pretty sure there is a choke, is it auto?

i think to od reads about 24,000 there is the black puddles when first start , and steam that clears up. Now I ran the car just before and checked the dip stick afterwards and there was a slight bit of cloudy oil on it. when the car was running there was the continuous greayish smoke and it...

I just checked the dipstick and there were signs of milkyness on it this could be due to the following thread, but doesn't explain the smoke.. the smoke is hurts your eyes like when a top fueler is running nearby. http://www.forabodiesonly.com/mopar/showthread.php?t=84304

Ok now that the condensation has cleared up I was just being a bit cautious. the condensation goes away but a smoke is still there , the car always did smoke a little bit when running , but seems to be more now not sure it maybe running rich...? what are your thoughts? What's the ideal oil to...

Hi everyone, I just revcently did my first oil change on my 72 Barracuda 318 that I just imported. I put in 4 litres of oil which was about 200mm over 4 quarts. I ran the engine for about 2 mins then checked the oil, realised it was slightly over and took some out, the dip stick then read, on...

I am pretty much a beginner when it comes to working on small block mopars. I purchased the car a few months back, and imported to Australia. I have removed the air conditioning and now I need to put on shorter belts to run my alternator. I have run into trouble as now the shorter belts...

I need a puller, you could just use some timber to chock it

Has anyone had any dealings with http://www.mysticalcudaenterprises.com/ I purchased a washer bottle kit for a 72 Barracuda over a month ago and have had no sign of it arriving. I attempted to call, the number is not in use. Their ebay store does not exist. I am worried that they have shut...

Hi there, I have a 72 Barracuda fitted with a Rallye Hood I am without washers / squirters to the windscreen washing system. Any ideas where I could source these ? Thanks jc