Search results for query: *

Who sells BRUSHED trim rings to fit the 8 inch wide Mopar rallye wheel? I have purchased the ones for the 7 inch wide wheels from Coker, but I don't see anything for the 8 inch wide wheel. Thanks!

Anyone know if there is a "Kit" available to restore a EBody OE air conditioner system?

Can the radio in a 72-73-74 eBody be removed (fairly easy) without removing the dash? Can the clock be removed without removing the dash? I have done "Dash Diving" in earlier models and I know it is usually not easy or fun. Thanks for your input.

Where is the best place to buy nice, inexpensive battery cables for my 73 Cuda? I don't want the clamp on ends and not looking for Concourse stuff. I want them to look nice and clean and to function properly. Thanks!

Are there any "less expensive" re-pop exhaust manifolds available to replace the 69-70 manifold numbers 2863549 and 3418623? Anyone running 350-400 horsepower thru their/with their original 1973 factory e-Body manifolds? My engine builder says get rid of the 1973 factory originals on my Cuda 340...

My 73 Cuda has a 3.55 sure grip. I am upgrading the 340 to at least 400 horsepower. I plan to drive it quite a bit so I am going to change the rear end to a 3.23. Do any of you know of anyone running a 2:93? I'm thinking it wouldn't be able to get out of its own way out of the hole, but...

Almost home yesterday and my car quit running. Everything was working as it should up til then. Had to hold the gas pedal to the floor to get the car to re-start, but after 30-45 seconds of idling it would die again. Took the air cleaner off and it looked like gasoline was puddling in the...

Can anyone tell me what this is? While verifying the rearend on my 73 'Cuda, I noticed numbers stenciled on the passenger side of the housing. The housing is a 2881489 but the stenciled number appears to be an upside down "7" with a line under it and then the numbers 328 which are right side...

Looking for a pistol grip shifter for my 73 'Cuda console automatic. To replace the T-Handle shifter. I have heard of the Gunslinger model,but also saw some old posts about "Harms" shift handles. Any information is appreciated, i.e., price, quality. where to buy, etc. thank you!

Has anyone done an upgrade to their factory original 340 without replacing the low compression factory pistons? I am interested in finding out what kind of additional horsepower one could expect if they installed an (example) Edelbrock top end kit (Intake/Cam/Heads) and headers, or purchased...

I am looking for a clock re-set knob for a 1973 'Cuda Rallye Dash clock. I prefer to buy only the knob, but if you have a non-working clock you don't want to split up or working clock, I might be interested in buying the entire unit. Please PM me.

My 73 Cuda, as far as I know, has the original, unmolested 340 engine in it. The car has approximately 58, 500 miles on it. I would like to try to get a few more horsepower out of it. A very good friend of mine told me that putting different heads, intake and cam will help, but unless I am...