Search results for query: *

I have a 70 Barracuda, the Sport mirror on Drivers side is loose inside the mirror. is there a way to tighten something is side the mirror, any info would help

Thank You for Your Response, Im sure this Question has been asked a few times. I have asked fellow Mopar Associate, he has a extra steer box, so I'm going to send his away for repair, and give him mine when his comes back That way it's Plug & Play, I don't know what the phrase overboosted means...

I have a 70 Barracuda, the Power Steering housing is Leaking. Has anybody bought a seal kit to fix leak themselves. If so, are ther any Special tools needed, or a Rebuild shop that had been proven, with a reasonable turn around time.

Here's a 70 Barracuda I just insulated, Hope this helps

Are these parts still available, I'm interested mostly in the LH side, I would offer you $75.00 for the parts. If interested what would shipping Cost to San Jose,Ca.Thanks Ken

Juan, thanks for the Information, Much Appreciated, I'm going to drop in tomorrow, thanks Again

Where should you start the Butle Tape when installing a New Windshield in a 70 Cuda

Thank You for Your Honesty

Do you still have the part,I'm mostly interested in the fan switch. I Broke mine while removing the dash to replace the pad.

Ken Hyslop 6779 Crystal Springs Ct San Jose, Ca 95120

Check is in my mail box, it should go out tomorrow, Thanks Drake

I'll be in at $80 plus shipping, Sorry but that's all I can do

I'm interested at $65.00 What's shipping to California

Termco uses Factory 4Spd Tunnels, Fits with out altering Factory hump

I have a 408 Stroker, with a 486 Case with a 410 Sure Grip, and a Tremco 5Spd, it was one way of putting the Power. Own light to light and still have Freeway Speeds over 75 Mph if needed

Just did my Lettering and Trim Rings, hope this helps

No Sway Bar on this car. Caliper on rear, thanks for asking

Sorry about being vague, The kit was suppose to be a complete drop in. However the porpotional value hit the LH Fender well when installed. I made a New Bracket which dropped the Porpotionsl valve lower & then turned the valve 180 degrees. This ment Flaring new lines, which ment buying a Double...