marks ebody
Well-Known Member
1970 challenger convertible.
318/904, 8 3/4 ,3.23 Numbers matching if that’s important to you. Has Fender tag, Dash tag,Door tag and Cowl Core support numbers. No build sheet. Factory Rally red,Black interior, Bucket seat, center console,Power top,power steering. Interior is extremely nice With no modification to front and rear Interior panels,Carpet,seats again super nice. Center console has no cracks. Rally gauges are brand new with new dash bezel. everything works but the radio. Install a heater core with foam kit.
Since the last time I listed the convertible (10/10/2025).
I have Installed New complete front big bearing dis. brakes, Upper and lower ball joints, lower control arm bushings ,Front shocks ,front sway bar,778/779 torsion bars, and new master cylinder.
In the rear install 340/383 Rear springs (to match the front torsion bars), replace the front and rear springs bushings, install the factory, rear swaybar, new rear shocks, u-joints.
Installed Accurate T/A exhaust
Installed AMD one piece trunk floor.
Replaced typical engine parts because it was off the road since 2008
Rims are factory Mopar with part numbers 15 x 6 1/2 upfront 15 x 8 rear.
It is currently licensing paperwork is in my name.
The bad, needs a dash pad, needs paint, needs lower quarters, and top.
Comes with a complete new black top, inner boot, and outer boot.
left and right lower patch panels. $48,500.00
318/904, 8 3/4 ,3.23 Numbers matching if that’s important to you. Has Fender tag, Dash tag,Door tag and Cowl Core support numbers. No build sheet. Factory Rally red,Black interior, Bucket seat, center console,Power top,power steering. Interior is extremely nice With no modification to front and rear Interior panels,Carpet,seats again super nice. Center console has no cracks. Rally gauges are brand new with new dash bezel. everything works but the radio. Install a heater core with foam kit.
Since the last time I listed the convertible (10/10/2025).
I have Installed New complete front big bearing dis. brakes, Upper and lower ball joints, lower control arm bushings ,Front shocks ,front sway bar,778/779 torsion bars, and new master cylinder.
In the rear install 340/383 Rear springs (to match the front torsion bars), replace the front and rear springs bushings, install the factory, rear swaybar, new rear shocks, u-joints.
Installed Accurate T/A exhaust
Installed AMD one piece trunk floor.
Replaced typical engine parts because it was off the road since 2008
Rims are factory Mopar with part numbers 15 x 6 1/2 upfront 15 x 8 rear.
It is currently licensing paperwork is in my name.
The bad, needs a dash pad, needs paint, needs lower quarters, and top.
Comes with a complete new black top, inner boot, and outer boot.
left and right lower patch panels. $48,500.00
Last edited:
