1970 Cuda Convertible (Non-Power to Power)

[Finoke]

The correct 30 amp breaker is available from classic industries but it’s expensive. I bought a generic 12 volt 30 amp breaker from ebay, it just doesn’t sit in the fuse block.

 

[Finoke]

Does anybody know if the pins that go through the actuator rods are available new?

 

[SteveLTCuda]

Does anybody know if the pins that go through the actuator rods are available new?

I think you can use the same pins and clips that are in the non hydraulic assist cylinders?

 

[SteveLTCuda]

I think you can use the same pins and clips that are in the non hydraulic assist cylinders?

 

[Finoke]

Hey Steve, My pins were really nasty. I actually just found new ones at
convertibletopguys.com

 

[SteveLTCuda]

Hey Steve, My pins were really nasty. I actually just found new ones at
convertibletopguys.com

Great! So are they the same pins used on both convertible top options?

 

[Finoke]

Great! So are they the same pins used on both convertible top options?

not sure

 

[Brcuda7t1]

If you need the dash sticker/plate and your car has the manual pump washer (not electric) I had to buy 25 stickers to get one. I can send you one for free if you PM me. Also if you need behind the dash pictures of the convertible dash section, let me know, my dash is still out of the car.