71 Cuda tail panel moulding clip reference

[gf7cuda]

Hello
need a little help, replaced my rear tail panel on my 71 cuda and I'm looking for location reference to drill holes for clips. Also need to know how many holes to drill. Thank you in advance......

 

[tommie69]

too dark here now. Ill take a picture tomorrow of the original one I took off my 71.

 

[gf7cuda]

thank you Tommie, appreciate it!

 

[tommie69]

I just took a few pictures. From left to right I measured. The top holes line up with the bottom perf6. The two side holes,one on each side are in the same location just below the half way mark. I took a few pictures

 

[tommie69]

I wrote the numbers down where each hole lands like I said left to right. Take a look at where I started the tape to get an idea. First hole is at
1 1/2"
Then 9"
16"
29"
39 1/2"
49 1/2"
56 1/2"
63"
If you need any more I fo just ask

 

[tommie69]

**** sorry first hole is 2 1/2"

 

[gf7cuda]

Tommie, thank you very much this is a huge help Appreciate it a lot!!! I just couldn't find this info in my manuals. Have a good weekend!