73 barracuda fuel tank vent line location pic needed.

[Flathead31coupe]

Looking for a picture that shows the metal line from the tank vent.How it comes up on the passenger side and attaches to the inner fender , next to the windshield washer fluid tank.. Thanks

 

[Ohiowoodchuck]

Here is what I got from my 74 manual. This is how I done it.

 

[Flathead31coupe]

I have got those pictures already.Thank you though I appreciate them.. I was trying to see how the metal line runs up the inside of the inner fender , beside the washer bottle..

 

[Ohiowoodchuck]

It hooks up to the charcoal canister by the washer tank.

 

[Flathead31coupe]

It hooks up to the charcoal canister by the washer tank.

Sorry I know that.. But where are mine is mounted?There is no way that the washer bottle can go in that position.So I'm just wondering how it mounts to the inner Fender in relationship to the washer bottle.Thanks

 

[Flathead31coupe]

After looking at the lower balance , there are five mounting points for the grill.. The two outward mounting points have oval holes in the metal tabs... And the three mounting tabs on the bottom of the valance have Round holes.. I will be taking it off later in order to figure out the u clips placement i am pretty sure the clips go on the metal tabs on the bottom. Of the valance..

I found a piece on the internet that says the u clips mount to the plastic grill on the lower grill , where it mounts to the three tabs on the valance.. Can anyone confirm this thanks.

 

[terrywalker]

I can maybe give you a little insight using my 72 Challenger. The canister bracket was originally mounted on the inner fender just forward of the washer bottle. There are 3 nut inserts mounted in an upside down Y configuration on the inner fender panel. I moved mine around 90 degrees to the radiator side support panel to use a non-Ebody charcoal canister bracket. The canister is still in the same area as it was originally. I looked on computer at the engine bay photos for a 73 Barracuda and the line and canister location looks the same as a Challenger.
Terry W.

 

[Flathead31coupe]

I can maybe give you a little insight using my 72 Challenger. The canister bracket was originally mounted on the inner fender just forward of the washer bottle. There are 3 nut inserts mounted in an upside down Y configuration on the inner fender panel. I moved mine around 90 degrees to the radiator side support panel to use a non-Ebody charcoal canister bracket. The canister is still in the same area as it was originally. I looked on computer at the engine bay photos for a 73 Barracuda and the line and canister location looks the same as a Challenger.
Terry W.

View attachment 152698

Thanks a bunch