73 barracuda rear valance mounting screws orientation verification

[Flathead31coupe]

I recently bought a mounting kit for the rear valance. It has 4 nuts 4 studs, 2 smaller hex bolts and two smaller phillips head bolts.. I know where the four studs and nuts go.. Best I can figure is the two smaller phillips head screws go in the center supports and the two smaller hex bolts go at the top of the valance on each end.. Not sure

 

[pschlosser]

I recently bought a mounting kit for the rear valance. It has 4 nuts 4 studs, 2 smaller hex bolts and two smaller phillips head bolts.. I know where the four studs and nuts go.. Best I can figure is the two smaller phillips head screws go in the center supports and the two smaller hex bolts go at the top of the valance on each end.. Not sure

Did you have a question in there, somewhere?

While I'm working with memories from a 1970 car, the phillips head screws go into the holes at the top of the rear valence panel.

 

[Flathead31coupe]

Did you have a question in there, somewhere?

While I'm working with memories from a 1970 car, the phillips head screws go into the holes at the top of the rear valence panel.

Lol sorry about that.There is only two phillips heads , and I think they go in the center of the valance where the two brackets are and the other two hex screws go on each end.. I guess that's not really a question.Rather needing verification , l o l...