WTB 8.75 Stuff Wanted

[Odin]

I need the following:

Good 3.55 ring/pinion gears with 10-spline, and
Sure grip carrier.

I will be selling a set of 2.76 ring/pinion gears (10-spline) for a 742 housing, a 7260 yoke, and an open carrier once I get all the stuff I need

 

[DALTON]

I need the following:

Good 3.55 ring/pinion gears with 10-spline, and
Sure grip carrier.

I will be selling a set of 2.76 ring/pinion gears (10-spline) for a 742 housing, a 7260 yoke, and an open carrier once I get all the stuff I need

I have the 3.55 ring/pinion off my AAR available....I'll have to check the spline count....you still needing these?

 

[DALTON]

It is a 10 spline if you are still looking.

 

[DALTON]

 

[Odin]

Thank you. For clarification, are they from a 742 housing? Approximately how many miles are on them?

I should be back in the country in a little over a week to work out a deal with you.

 

[DALTON]

Thank you. For clarification, are they from a 742 housing? Approximately how many miles are on them?

I should be back in the country in a little over a week to work out a deal with you.

Just discovered it's for a 489 housing sorry buddy!

 

[Rob C]

Just discovered it's for a 489 housing sorry buddy!

Interested!
PM on what you want for them.

 

[Odin]

Just discovered it's for a 489 housing sorry buddy!

Well I do have an extra complete 489 differential but I was hoping to build the empty 742 housing and have both in the end. We might still be able to make a deal. Let me get back to you.

 

[Cudafor36]

I have a 741 pig that's coming out when my new 489 one arrives. It's a 3:55 posi. Just time for bigger bearings as I'm feeding it with a new 392 hemi. Runs and drives fine even at 100mph. I did recently though have to put 12oz of fm in her. 7345453794. Peter