FOUND Challenger Slant 6 3spd Driveshaft

[67440NewYorker]

Needing a driveshaft for our 70 Challenger Slant 6, 3spd manual car. I think we have the right yoke but if we can find a complete driveshaft that would be great! And the measurements we have found are around 45 and half inches from center to center of the ujoints.

 

[upnover]

i have one from a cuda but id guess they are differant, if not send me a pm

 

[slantfish]

I can do a measurement when I get home tonight (if I remember, lol). mine is a '70, same combo (built at the LA plant, 1st week of production)

 

[slantfish]

47 1/8" total end to end (top of the u-joint castings)

I also just found this that is MUCH better Driveshaft length in Engine, Transmission & Rear End

based on the charts, should be 45.79" center to center on the u-joint caps.

 

[upnover]

Sorry for the delay, just measured mi e and it's 46 1/4" cap to cap on the shaft itself. It's from a 70 barracuda slant six 3 speed. Pme if you can use it.