WTB Cuda belt moulding

[Xghobo]

Looking for Cuda door trim/belt moulding.

Thanks all

 

[QuickBpBp]

Which side?

 

[Xghobo]

Which side?

Both but will take 1 side and look for the other.

 

[QuickBpBp]

Ok I will believe I have the driver's side. I will look in the next day or so.

 

[Xghobo]

Ok I will believe I have the driver's side. I will look in the next day or so.

That would be great as I think I have a line on a pass side!

 

[QuickBpBp]

I got involved in some snow removal.. Way more than they said it was going to be. I am off tomorrow so I can get it and post pictures if still needed.

 

[Xghobo]

I got involved in some snow removal.. Way more than they said it was going to be. I am off tomorrow so I can get it and post pictures if still needed.

Thank you yes still needed my friend

 

[QuickBpBp]

Thank you yes still needed my friend

Here it is. I see 2 small dings. One a pencil point “in” and one “out” very straight. Judging by the end taper I believe it is Driver’s side. Pm any interest.

 

[Xghobo]

Looks like your PM are full, if you can clear that up pm me

 

[QuickBpBp]

Looks like your PM are full, if you can clear that up pm me if not feel free to email me at

Made some room.. I would remove your e-mail so you don't get a scammer contacting you as me..

 

[Xghobo]

Also looking for clip and nut for end at door where it meets quarter

 

[QuickBpBp]

Also looking for clip and nut for end at door where it meets quarter

View attachment 149992

If anyone can get measurements of these I can look as I have some nos clips and I have another guy looking for some clips. So if I come across them COULD help..

 

[6PKRTSE]

Also looking for clip and nut for end at door where it meets quarter

View attachment 149992

I just made my own out of flat stock steel. I cut a square to fit with the channel, drilled a 1/4" hole, welded in a 1/4-20 studs and ground smooth on the top side.

 

[QuickBpBp]

So I took some time to look this evening and I believe these might be the ones…If anyone can confirm size with an original. If not I know I have some other nos clips to look for…

 

[tullm]

@QuickBpBp
The clips in you're photos in post #14 appear similar (maybe the same) to those used to mount V*X mouldings at each end of the doors on 1970 - 1971 Challenger (maybe other locations for said moldings as well).

 

[ldr]

do you still need the moldings? call you have the number