High flow air filter with limited space on 440.

[challenger512]

Hello.

I have a 440 stroker 512 with Trick Flow heads and intake with a Holley Sniper x Flow and this air cleaner dou to limted space

K&N 66-3110 - K&N X-Stream Airflow Assemblies.​

Anny of you have a solution to get one with high flow of air.

 

[Chryco Psycho]

something like this might work

Holley 64280 Polished Aluminum Hi-Tek Low Profile Air Cleaner Filter Assembly | eBay

Housing is constructed from highly polished cast aluminum, Features 2 high-flow K&N style air cleaners, Measures 18" long, 8" wide, and the filters have a height of 2.625", Designed to fit all popular 5-1/8" neck carburetors, Integrates a solid top housing style.

www.ebay.com

I have seen similar ones with 2 4" round filters pointed forward but I can't seem t locate one right now .

 

[Chryco Psycho]

Like this

Spectre 771 Cold Air Intake Kit, Low Profile Dual Plenum Inline, 45x90 | eBay

Designed to fit 5-1/8 inch inlets on TBI throttle bodies and carburetors, The air intake tubes bend down at 45 degrees with a forward 90 degree bend, Tubes will accommodate any clamp-on air filter fitting a 4 inch tube, Made from lightweight aluminum with a polished finish, It is easy to install...

www.ebay.com

or this one

SPECTRE 9824 Polished Fabricated Aluminum AIR INTAKE<>4" DUAL PLENUM low profile | eBay

This is an ultra low profile, fabricated sheetmetal, polsihed aluminum, Spectre Performance air intake plenum with dual, 4" inlets that are 120 degrees apart. It has a 5-1/8" flange that fits Holley and many other carbs. It is Spectre part number #9824. Features: 120 degree angle between air...

www.ebay.com

 

[1972 AAR Cuda]

Hello.

I have a 440 stroker 512 with Trick Flow heads and intake with a Holley Sniper x Flow and this air cleaner dou to limted space

K&N 66-3110 - K&N X-Stream Airflow Assemblies.​

Anny of you have a solution to get one with high flow of air.

What is your setup ? Dual plane or single plane intake?
Flat stock hood or dual scoop hood?
Spacer added for carb?
I installed a stock 4 barrel intake manifold and a stock low performance single snorkel 4 barrel air cleaner I found at a swap meet. My problem was I was struggling to get an air cleaner to fit under the hood so in this case on the underside of the air cleaner I drilled holes to increase air flow - the single snorkel air cleaner opening was pretty small, but it sat low on the engine.
This fits (barely) under the flat hood so I will be adding a dual scoop hood to increase space for the air cleaner in the future.

This of course is a 360 small block, but performance is pretty good. Mid 13.50's in the quarter (so flow still seems adequate).
Not sure if that helps, but maybe it gives some ideas on options...

 

[73Dodge]

I've got a 440 stroker as well, running a Street Dominator intake with a 1 inch Wilson Manifolds spacer and an 850 double pumper. I'm using a Summit racing drop base filter set up, it just clears. Here's an older pic (the Holley heat shield is gone now). Summit Racing