I am looking for a little help on assembly of the column key release lever on my 73 Challenger. Does anyone have information on the spring location and connection for the column. I have looked at the video posted on assembly of the column, but the column shown does not have the release lever. Also the video posted by Cuda Cody shows his contact info (web sites) but the sites are not secure and will not allow me to access Any help would be appreciated, Thanks.
Key release
- Thread starter eabodywkr
- Start date
Challenger RTA
Well-Known Member
Dont know if this is a help. If I remenber, the sping arches over the center some how and the is a round stub it goes on. Others might know better or have a picture.
I have all the parts and I'm pretty sure the springs round end goes on the pin I have it on. Not sure where the other end goes.
OK I got the spring figured out. The other end attached to a small hole in the tube. Now is there supposed to be a spring washes on the end of the tube before installing the release lever. My column did not have a washer when I disassembled
Similar threads
