Looking for Federal style PS Pulley

[Ship Rider]

Mine is warped! Does anyone have one to sell or know of a source for this press on style pulley? The shaft is 5/8 inch and the diameter is 7 inches. Not sure how to measure or determine the offset for lining up with the crank. I need it for a 440 setup. Car is originally a 318 73 Challenger and I believe the pump is original to the car.

Thanks

Jamie

 

[challenger6pak]

Post a pic.

 

[Ship Rider]

Pictures

Here are pictures of the pulley. Hope someone out there has one to sell!

Jamie

 

[challenger6pak]

Is it your pulley or your shaft. You may be able to get a rebuilt pump and a parts house. The pump might be the same but the brackets will be different between the 318 and the 440.

 

[a440plus6]

Rebuilt pumps usually don't come with pulleys or reservoirs.

 

[challenger6pak]

Rebuilt pumps usually don't come with pulleys or reservoirs.

Yes, I forgot about that.

 

[Ship Rider]

Pump is a rebuilt and just put on. I did hope it was the shaft but it was the pulley. I am looking at switching everything over to saginaw setup. I would like to make the engine look a little sharper anyway.