Rear window clip stud location

[jimbyr]

Does anyone have a dimension for the rear window clip studs? There are no studs on my 71 Challenger so it looks like I'm drilling some holes and need a dimension either up from the bottom of the channel or from the top of the channel down. From the top down would probably be more accurate

thanks
Jim

 

[Adam]

It might be helpful to mock up the clips you are going to use, with the trim, and a spacer to approximate the window and sealer thickness. This is because reproduction clips will likely be different and some repo glass is thinner.

 

[challenger6pak]

I have photos and measurments on where the clips go. Send a pm to me with your email address and I'll send you a copy of the pics.

 

[moparlee]

I have photos and measurments on where the clips go. Send a pm to me with your email address and I'll send you a copy of the pics.

Not hyjacking the thread, but I need the same information for my 71. Tried sending a PM but your inbox is full.

 

[challenger6pak]

Maybe I can post the pics. I don't know how many there are. I have them on a separate hard drive that is not with me right now.

 

[moparlee]

Ok, thanks. Todd, I need the locations and measurements for both the front and rear window trim clips.

 

[tommie69]

Not hyjacking the thread, but I need the same information for my 71. Tried sending a PM but your inbox is full.

x2