On by 70 Barracuda, the sail panels is falling off. The driver side is missing. How is the top of the panel secured? the front and rear of the panel is covered by the metal moldings and the bottom is under the plastic rear panel. the top is not secured to anything. Is something missing? Thanks.
Sail Panel Installation
- Thread starter money pit
- Start date
Xcudame
Well-Known Member
Nope! The top just fits snug against the headliner.
Mine are little warped and tattered. I'm going to replace them. Thanks
Challenger RTA
Well-Known Member
When I did mine. I made them out of a plastic material. There were 3 clips that held that held it in place. Not sure about Barracuda. The hole might be there to use the clips.
Last edited:
The Barracuda is different, I don't know why. I heard the metal trim holds the sail panel in place. Thanks
Solarguy
Member
The coat hooks help hold the top edge in place
My coat hooks are missing. Thanks
Xcudame
Well-Known Member
I went out a took a picture of the sail panel in my 71 Barracuda to show the coat hook holding the top. the sides and bottom are helped held in place by the interior trim/mouldings and the rear side panel. So except in the case of warped ones, they fit in there pretty snug.
heminut
Well-Known Member
I don't have the coat hooks in mine and the panels stay in place without them. I did put new panels in when I put the new headliner in years ago, and they are still fitting good.
Thanks. I think I will install the coat hooks.
Similar threads
