steering problems

[racer939393]

I am rebuilding a 1974 dodge challenger 360 with power steering. My problem is on the driver side the inner tie rod hits the torque rod. I have no problem on the rightside. It is not possible to turn the wheels to the left. I have all new pitman arm, tie rod ends, idler arm and spindles. Any help you be great.

 

[moparleo]

Welcome aboard. Do you still have the old parts ? Do you have a manual to show you the proper way to replace the steering parts ?

 

[racer939393]

no I do not have the old parts. I do have a manual.

 

[moparleo]

If the pitman arm was installed properly, the only thing that can be put on incorrectly is the center link. It can go on 2 different ways but only one way is proper. What do you mean by torque rod ? Picture ?

 

[racer939393]

sorry new Mopar man, tie rod is hitting the torsion bar. tried putting on the center link the other way and it hits my oil pan, it is a aftermarket oil pan.

 

[AUSTA]

I am rebuilding a 1974 dodge challenger 360 with power steering. My problem is on the driver side the inner tie rod hits the torque rod. I have no problem on the rightside. It is not possible to turn the wheels to the left. I have all new pitman arm, tie rod ends, idler arm and spindles. Any help you be great.

is the vehicle on a post lift or on the ground

 

[moparleo]

Can you give us all of the information of what else is not stock? A picture would be the best. Did anything other than the steering linkage get replaced at the same time ?

 

[racer939393]

I have aftermarket strut rods from QA1, new spindles for disc brakes, new ball joints upper and lower, everything else is stock. I'll try to get a picture. thanks for helping me.