Recent content by Ctriton20

I’m running a 8-3/4 rightnow.

On my 1973 Challenger, I went with the 400/512 stroker with trick flow 240 heads. It made around 580hp at the wheel on the dyno. I removed the 3.91 and installed 3.23 for drivability. Running a 3 speed trans by A&A.

Would it be safe to say that using the horsepower to torque calculator that my dyno reading of 525 ft -lbs at 5850 rpms equals 584.8 hp at the wheel?

That looks great! Did you notice any power gains?

Went to the dyno today! This shop had a Mustang Dyno. Not sure why it made more torque than horsepower. The AF ran around 12.5-14. I was running 38 degrees of timing. I added new tti step headers and 3" exhaust since the last dyno. I guys at the shop think that my converter is killing the...

Before number 6 wasn't firing. I also installed new tti headers and exhaust. (2'-1/8" step headers and 3 exhaust). Got a better tune setup. I'll let you guys know how it goes.

I'm going in for a followup dyno Tuesday. Before number 6 wasn't

Thanks! That's what I needed to know.

Hey Guys! I thinking about having Wilson Manifold port my Trick Flow intake and add nitrous bungs. Have any of you guys had one done? What kind of horsepower gains did you see? Thanks

10" 3400-3800 Stall

I’m going to do some tuning and follow up on the same dyno.

I posted my engine dyno sheet in our forum. It made 665hp at 5800 and 691tq at 4500. Put the car on the dyno with full trim and it only made 480hp at 5800. That's a massive lost guys! 400/512 stroker with trickflow 240 heads 10.5cr.

Hey Guys! I want to know. How much engine horsepower is lost at the wheel on a big block mopar with a 727 trans and 3.91 gears?

Didn’t have much body work to do. Clear coat needs to be touched up a little. I will be out $5k when all is done including materials. Most shops are going to want 10k-15k these days.

Just finished paint and tires on my Challenger. I used Viper Red for the paint and for tires 245 in the front and 305 on the back.