WTB ‘70 Challenger SE Rear Vinyl Roof Moulding

[Morpheus]

This is the very hard to find moulding that wraps around the rear end of the vinyl roof area. I believe it is wider than the standard moulding - 3/4” as opposed to 7/16”

 

[Mopar Sal]

This is the very hard to find moulding that wraps around the rear end of the vinyl roof area. I believe it is wider than the standard moulding - 3/4” as opposed to 7/16”

I have this , new. Bought for a 70 challenger

 

[Morpheus]

Ok. Is it an OEM part? as I didn’t think anyone currently made a reproduction of this particular moulding

 

[62Dodge_]

Howdy If this is the long pieces, two, of trim that covers the edge of the vinyl below the rear window I have them. I bought them for my Cuda' and discovered that they were for a Challenger. Thank you Bob

 

[moparlee]

I have this , new. Bought for a 70 challenger

View attachment 143290

I think he is looking for the outside stainless trim.

 

[Mopar Sal]

Ok. Is it an OEM part? as I didn’t think anyone currently made a reproduction of this particular moulding

Not sure, bought in a collection

 

[Mopar Sal]

Ok. Is it an OEM part? as I didn’t think anyone currently made a reproduction of this particular moulding

This is for inside trim

 

[62Dodge_]

Howdy. I'm not sure exactly what is needed, rereading it again I'm still confused, I will play the old guy card. When I get home I will upload a picture of what I have.

 

[Morpheus]

Howdy If this is the long pieces, two, of trim that covers the edge of the vinyl below the rear window I have them. I bought them for my Cuda' and discovered that they were for a Challenger. Thank you Bob

Hi Bob, I have the thin strips that hold the vinyl in place, but as Moparlee says, I require the outside stainless moulding that goes over them. It is 3/4” wide

 

[Morpheus]

This is for inside trim

Ok, no problem. Thanks for looking though

 

[Mopar Sal]

Ok, you’re looking for exterior trim,
Not for you

 

[62Dodge_]

Howdy. Here is a picture of what I have, I was wrong three pieces. I laid in my 2015 to show kinda where it lays. Let me know if this what you are looking for.

 

[Morpheus]

Hi Bob, that looks like it could be right. Can you take a measurement of the width of the stainless moulding please. It has to be 3/4” wide to be the correct SE trim. Thanks

 

[62Dodge_]

Howdy I hope that you are having a wonderful weekend. I was out in my shop and I got some measurements it looks like we have a winner. Here they are let me know your thoughts.