3 speaker dash gril

[Ante778]

Hi!
Please Can someone give me outer dimensions as well as holes CC dimensions for screw holes. I'll try to make my own, of the right and left speaker grill!

 

[tonysrt]

I can give you outside dimension of grille for the left & right speaker is approx. 4 1/2" from windshield and 5" wide. Grilles are screwed in and impossible to give you how the grille screws are positioned. I don't remember if the grilles had studs or use screws to secure them. Probably did it 30 years ago but car came with 3 speaker dash.

 

[tonysrt]

The grilles are also curved to match the dash. Probably easiest is to find a used set, unless they repro them. You would probably have to use something fairly thin to follow the curvature of the dash. The grilles are about 3/4" from windshield.

 

[Ante778]

I can give you outside dimension of grille for the left & right speaker is approx. 4 1/2" from windshield and 5" wide. Grilles are screwed in and impossible to give you how the grille screws are positioned. I don't remember if the grilles had studs or use screws to secure them. Probably did it 30 years ago but car came with 3 speaker dash.

 

[Ante778]

Ok!
understand it is hard to find! I know it is curved but that can i meaesure from my new daschboard. It would be fine to have the measure between the screw hole!

 

[rbbruno3]

3 7/8” + -

 

[tonysrt]

After seeing above post went out and looked at mine again and in NY we have a big registration sticker that actually blocked those 2 screws that made me think it was secured under dash. Glad somebody else had it loose to show you.

 

[fasjac]

Damn. I have two somewhere. I’ll look tomorrow and if I can locate them will measure for you. Like the rest have mentioned the curvature and how close to the the glass they are, the originals would look the best.

 

[fasjac]

I cannot locate in a timely manor. I do have em with speakers. Sorry

 

[fk5aar]

Isn’t there a rh and lh? Mine are marked lh and the but they both seem to be the same and fit on the other side....

 

[tonysrt]

There is a different part # for left and right grille so must be different. 70-71 Cuda the same # and only 71 Challenger same part #. Evidently 70 Challenger different.

 

[Ante778]

View attachment 70926 3 7/8” + -

I can also get measurements from the back and the ring that is there and the diameter of it. and maybe the thickness and a picture on the top so I can see where the radius begins.
(Very grateful for the help from everyone thanks!!)

 

[tonysrt]

The best way to get the curvature would be a thin piece of tin and place over the opening and press down to get correct shape. Maybe cut up a tin can with the dimensions above or even a piece of smoke pipe.