AAR Hood to Radiator support seal

[Tom's EK2]

I've seen some AAR's with the rubber hood seal and some without. I had to repair my fiberglass hood, so I don't have any holes in the front to mount this seal. What is the correct mounting and thoughts on if they came with this.
THANKS

 

[don selleck]

i have a pretty original FC7 it has that installed still, not 100% sure on that I'm sure someone here has one that is more documented than mine, and can verify. I can measure holes in the next couple days if necessary.

 

[Tom's EK2]

That'll work!
Thank You

 

[don selleck]

That'll work!
Thank You

measurements are taken from left side of hood seal lays in channel except the 2 lower attachments, which are 6" from either side.

 

[don selleck]

the lower attchments are actually upper on the other side of the other 7, but I think you should be good, centered and laying in the channel

 

[Tom's EK2]

the lower attchments are actually upper on the other side of the other 7, but I think you should be good, centered and laying in the channel

Excellent!
Could you give me one picture showing precisely where the seal lays/fastened to the hood?

 

[don selleck]

like I said,

lays in the flat channel in hood centered

 

[Tom's EK2]

like I said,View attachment 130282 lays in the flat channel in hood centered

Perfect
Thank you. Just trying to figure it out. Still wondering but I'll get it sooner or later. Pictures worth a thousand words.