complete dash harness replacement and the signal lights don't work

[Golden Boy]

i think i have that one as well. forgot about it! the one i was curious about is located on the left side of the dash and uses a male connector
i had to replace the door connector on drivers door as i broke the original one taking the harness out . the threads looked clean for a good ground. i should look at the pass side one tho. Again, Thanks for the help and interest!

 

[Golden Boy]

i have everything working except the door switched dome light/map lite( yellow wire circuit). the pink wire circuit works when i ground the double yellow w \black tracer pigtail with male bullet connector. don't remember this being plugged in to anything previously) been thru the wiring diagram several times and don't understand why it doesn't work. wonder what im missing here. gotta be something obvious that im not seeing? door switches have good grounds.

 

[FrankenKuda]

I made my own lighting circuit schematic. Both Exterior and Interior. Old Plymouth's use a lot of body grounds and only provide fused circuits to the devices. As mentioned before be sure the grounds on the switches and lamps have good paths back to good grounds. To make it bigger, I cut off the fuel gauge at the top and headlamps at the bottom. I did this to figure out my Low Fuel Lamp and other Consolette lighting circuits for my GC. I hope it helps.