Nick McGee
Member
- Joined
- Nov 25, 2014
- Messages
- 7
- Reaction score
- 0
Console floor pan position – for column shifter car conversion to floor shift auto...
Hi guys, I've got 1971 Challenger that is a column shift (904) auto. I cut a trans console tunnel hump out of a wreck over in Texas (I'm Australian) to use as a graft.
I'm trying to figure out exactly where to re-weld the console mount onto my floor pan so the console sits in the right place and it will line up all the shift linkages?
Would anybody with a floor shift auto project consider measuring the mounts against some obvious positions on the floor for me?
Are there any factory drawings that might detail such measurements?
Much appreciated, Nick.
Hi guys, I've got 1971 Challenger that is a column shift (904) auto. I cut a trans console tunnel hump out of a wreck over in Texas (I'm Australian) to use as a graft.
I'm trying to figure out exactly where to re-weld the console mount onto my floor pan so the console sits in the right place and it will line up all the shift linkages?
Would anybody with a floor shift auto project consider measuring the mounts against some obvious positions on the floor for me?
Are there any factory drawings that might detail such measurements?
Much appreciated, Nick.
