1bolt@atime
Active Member
- Joined
- Aug 11, 2011
- Messages
- 35
- Reaction score
- 4
I replaced my torsion bars along with ball joints, LCA bushings, upper control arms, tie rod ends, steering box, pitman arm and probably something else I am forgetting. Set it down and it is leaning right by about 4" difference in height on the front. I replaced/changed nothing in the rear. The torsion bars are new pst. The left side seems correct in height - 25" at wheel opening, so I pulled the right side and dropped the LCA to about 8 o'clock and backed the adjuster out all the way. It looked as if I would be able to 4 wheel in it after that. Pulled the bar back out and the next way to install is putting it right back down too low. I laid the bar on the floor, it has no clocking to it.
I guess my next move is to pull the left side bar and see if maybe it HAS clocking. Anyone ever run across this uneven front end height issue? Any help would be appreciated. Thanks
I guess my next move is to pull the left side bar and see if maybe it HAS clocking. Anyone ever run across this uneven front end height issue? Any help would be appreciated. Thanks