replace ignition switch

[michael bucklew]

trying to replace the ignition switch...according to the shop Manuel the entire steering column has to be pulled. Is there another way????just went through loosening the column to link to new steering box. real pita

 

[Xcudame]

You can do it. It's still not fun. You'll have to remove the obvious tomato can and then eventually you'll get to the lock plate and it needs to come off. It's held on by a pin that Miller Tool C4113 makes simple to remove, but you can use a punch and hammer which is pretty crude. Just be careful! And of course the shaft is going to be in the middle of everything. So you can see why they suggest removing the whole column.

 

[michael bucklew]

You can do it. It's still not fun. You'll have to remove the obvious tomato can and then eventually you'll get to the lock plate and it needs to come off. It's held on by a pin that Miller Tool C4113 makes simple to remove, but you can use a punch and hammer which is pretty crude. Just be careful! And of course the shaft is going to be in the middle of everything. So you can see why they suggest removing the whole column.

sounds like yippie ki yea job

 

[michael bucklew]

Miller tool no longer available

 

[EV2RTSE]

It seems like a daunting task at first but just take it a step at a time as outlined in the videos and you'll do fine. I felt the same way at first when I started tearing into my column, but it's really satisfying when it's all back together. And I agree, the special tool(s) called for in the shop manual aren't really necessary.

 

[michael bucklew]

It seems like a daunting task at first but just take it a step at a time as outlined in the videos and you'll do fine. I felt the same way at first when I started tearing into my column, but it's really satisfying when it's all back together. And I agree, the special tool(s) called for in the shop manual aren't really necessary.

did you remove the entire steering column?? video where---You Tube????

 

[michael bucklew]

did you remove the steering column?? video where--You Tube??

 

[michael bucklew]

just watched a video..got the turn signal off..next. removed 3 screws holding the next part of the column..how is this removed????? video did not show how

 

[Challenger RTA]

Column in pieces.

 

[heminut]

I lost my keys and had to pull my ignition switch on my 70 Cuda to take it to a locksmith. It's been a while but I remember the only special tool I needed was a steering wheel puller with long bolts to pull the 'crush can'.

 

[Xcudame]

@Challenger RTA now that is in pieces!

 

[Xcudame]

@heminut is right, the Miller tool makes it easier, but it can be done with a punch and hammer. Just use common sense and don't beat too hard!

 

[mrmopar340]

@heminut is right, the Miller tool makes it easier, but it can be done with a punch and hammer. Just use common sense and don't beat too hard!

I've used another roll pin to push it out the other side so I could get the grips on it.

 

[EV2RTSE]

did you remove the entire steering column?? video where---You Tube????

Yes easier to work on out of the car.