Shaker hood conversion, anyone build one?

[6PKRTSE]

I received all of my parts. Let the cutting & hacking begin. Hood opening will be a couple of inches longer, base plate will be the same couple of inches longer & custom drop made to fit the dual dominator carbs, scoop will be longer as well as a few inches tall when it's all done. Essentially making it a "super shaker".

 

[mrjlr]

I received all of my parts. Let the cutting & hacking begin. Hood opening will be a couple of inches longer, base plate will be the same couple of inches longer & custom drop made to fit the dual dominator carbs, scoop will be longer as well as a few inches tall when it's all done. Essentially making it a "super shaker".

View attachment 48188

View attachment 48189

View attachment 48190

Badass!

Jeff

 

[6PKRTSE]

Per my other thread. Finally got out in the garage to work on the latest project a little. I had to reconfigure my outboard fogger around a little & lean the solenoids in a little to clear. I made all of my templates to start making my dualDominator tunnel ram shaker conversion Time to start hacking on the parts now.

 

[Turbobitt]

These pics were sent to me at one time. They are not of my work. I have done several conversions and they are easy. View attachment 47150 View attachment 47151 View attachment 47152 View attachment 47153 View attachment 47154 View attachment 47155 View attachment 47156 View attachment 47157 View attachment 47158 View attachment 47159

I know this is an old thread but can you detail how you determined the hole opening with regards to leaving the appropriate amount of material for the flange tool to work properly ?
Allan G.

 

[6PKRTSE]

Finished my Super Shaker up some time ago.