• Welcome to For E Bodies Only !

    We are a community of Plymouth Cuda and Dodge Challenger owners. Join now! Its Free!

What brand of rear shocks is everyone using?

Tried advance auto, and rock auto. Where is the best place to get these shocks for 71 gran coupe
 
Often the rear stance is affected by the setting of the front T bar on the opposite corner , have you tried adjusting the right front ?
 
Those Monroe shocks are new. Never seen that before, but the car was completely tore down. Makes sense that I didn't get it back together right.
 
Just an FYI Shocks do not support weight.
They are designed to dampen the compression/ rebound cycle of the spring to keep the tire in contact with the ground.
Air shocks support weight and are never recommended, They were a band-aid back i the 60s and 70s.
If the rear is too low, replace the springs.
But as Chryco says the front end could need the ride height adjusted.
 
you need to ask the aligement shop to do that it;s not done automatically .. raise the front to unload the suspension to adjust the torsion bars
 
He is aware of the torsion bars needing adjustments. Plus alignment.Getting done on Friday, weather permitting. Have to trailer it to the shop. Hoping this is the last time I have to get a trailer.
 
Here is some info. And have close to a full tank of gas or about 120lbs in the trunk
1742948354502.png
1742947892400.png

1742947989144.png

1742948306848.png
 
Back in 87 was the last alignment. Can't believe I found this document. Hope it is readable. I sure will give them the information you sent. Thanks !!!

174299509155760942399057524008.jpg
 
Won't be going to get the car an alignment. Rain in the morning, had an 8am appointment. Back in January had it scheduled and it snowed. Go figure.
 
Back
Top