Recent content by sfort

I will round them up and get them to you. What is you shipping address and how do i place an order and get you payed?

I am interested in a set of your Ebody hinges. Is the pricing above per door or car?

Needed good 73 Challenger Trunk Lid. Hopefully close to Ft. Worth TX.

I am looking for a door hinge and sure you can help me. 1973 Ebody. Are they universal side to side. My car came with the same part number on both. What are your terms. I need one large hinge. The other has already been replaced.

Does anybody offer a lower profile side marker for the 72/3/4 Challengers?

I had a strange thing happen to me a couple years ago. Filled up with gas and stopped at a stop sign a mile away. Engine died. Got it started and it run very poorly and did not want to idle. I thought "bad gas" and started working the issue from that angle. To make a long story short the metal...

Thanks Adam that's what I am asking for advise.

I have a 1999 360 magnum Durngo 4x2 automatic that was wrecked and is sitting in the drive. The car was driven home and parked and has sat for two years. My basic question would be what would be salvageable parts that could be a benefit to use inn my 73 challenger build. The car I am building...

The block and heads may have been decked or milled. Can you tell? Could the valve guides have been replaced and not installed properly?

There is all kinds of plastic inside the door attached to the glass. You are going to have to pull the door trim panel and look inside with a flashlight.

1970 cuda guages - $250 (rockwall)

Wow! I cant believe it has taken a year to get this far. I went with Firm Feel for their Kmember kit (alot of welding), LCA kit, and UCA's. Did all the welding myself (TIG) so there was a learning curve involved. Once that was done I ordered US Car Tools Kit for frame connectors, fender braces...

Yes it is!!!!!!

Have you already scraped your old frame rails?