Search results for query: *

Hello. I have a carb problem with my Holley 650 double pumper. The engine will start however the idle drops right down and it quits after a minute or so. I removed the manual choke and butterfly in the carb since it was closing on occasion. Are there any holes that need to be filled in ?? I...

Hello. Any suggestions / recommendations on how to change the front motor mounts on my 74 Barracuda with a 340. I'm a newby to this task. Thanks !

Hello. I get a vibration at certain RPM while the vehicle is in park through the floor of my 74 Barracuda. Feels like it could be something in the torque converter or transmission ?? It will go away at higher speeds & different RPM ranges ?? Please help. Thanks !!

Left rear tail panel chrome trim in good condition. $40.00

Hello. Does anyone have a pic as to where this plastic part mounts to the frame ? Thanks !

Hello. Has anyone installed one of these units ? How do they perform in a small block Barracuda for a street car ??? :glasses2: Thanks!

Hello. What temperature Thermostat should I run in my 340 ?

I have various parts for sale for a 74 Barracuda. Chrome upper door top trim. Two upper control arms with ball joints. Too many to list. Let me know what your looking for.

Hello. I get a front end bounce at 60 mph. I have had the front wheel balanced three times and I still get a front end shimmy or hopping ??? Please help, thanks.

Hello. I have an issue with my starter cracking even with the ignition switch turned off ? Bum ignition switch ????

Hello. I get a miss with hard acceleration. It seems like an ignition miss or carb issue ???? Help, thanks

Hello. I put a 750 Holley Reman double pump carb on my 340 and I notice with hard acceleration that I get a slight sputter and the odd backfire. Am I too lean ? Jetting issue ??? Holley recommended I increase the fuel squirter size to a .35. Please help. Thanks !

Rebuilt 650m Holley double pumper for sale. Excellent condition. Will trade for Accel or MSD small block 340 cu. inch distributor.

I have a starting problem now since winter storage. 340 with Holley 650. Car starts but have to keep revs up to keep running ?? Possible float stuck in Carb ??

Would a 750 single feed be too much carb ? Unsure of camshaft duration ??:confused1:

Looking for a good rebuilt TQ 800 CFM carb.

Looking for a set of front bumper brackets.

Is there any easy way to adjust the front hood height above the rubber bumper stops. Raise the rear of the hood at the windshield?

Hello. I was told this may be too much carb/fuel for a 340 ???? Anyone experiment out there with different carbs...single feeds. I heard Edlebrock 750 single feed was a good choice ??

Hello. Any suggestions of a tire brand and size of tie for the front of a 74 Barracuda with a 15 x 7 inch wheel. 4 1/2 inch BS.