1973 Challenger reproduction fenders and doors

[pistol grip]

Has anybody used any reproduction fenders or doors for a 1973 Challenger? I was wondering on who made the best ones and how was the fit. Thanks

 

[DetMatt1]

If AMD is making them(fenders), they’re the best. I haven’t looked at a recent catalog.

 

[Adam]

Agreed. I have used Goodmark and AMD fenders; AMD is far better; I would avoid Goodmark.

 

[ProHemi572]

AMD for sure!

 

[Adam]

Here is a Goodmark fender and AMD door skin. They didn’t match; I had to weld a small piece of welding rod to close the gap. I had to do this to both sides, ie Goodmark fender to factory door.

I recommend you use the same brand fender & door, but you should still expect they will need some work.

 

[Adam]

My new driver’s side Goodmark fender in the above post was eventually scrapped and replaced with an AMD. It was about 3/8 too short. When the hood was put on the fender it wasn’t even close to the front edge of the hood. If I slid the fender forward the door gap was huge.. also, the fender was bowed outward along the hood gap making it impossible to get a straight hood to fender gap. Lastly the Goodmark fender did not have the correct threaded number adjustment fitting, as shown on this original.

That was a few years ago, I do not know if Goodmark improved, but all the
AMD stuff was excellent.