accelerator cable issue

[moparmaniac10]

I have a 440 in my 71 challenger and it has a edelbrock rpm performer intake and a Holley 4160 carb. My issue is that the end of the accelerator cable has a "U" shaped end, which is stock, and I cannot find the pin that goes onto the carb to connect the cable to the side of the carb in the correct location. Does anyone have a Holley carb on their car and how did you fix this issue. The intake is alot higher too, and I found a longer cable, but it still has the same end on it.

 

[moparleo]

Try Mancini Racing: for linkages and brackets

http://www.manciniracing.com/

 

[Avalanche]

I needed to install this on the side of my holley avenger to line up the cable and make the pedal a little easier to depresss.
http://www.summitracing.com/search?keyword=Holley Throttle Lever Extension

I would call them and make sure it works for you.