Double Scoop (Sport) Barracuda Hood

[Claudia]

Does anyone know if there is any type of actual gasket that goes between the hood and the actual scoop?

 

[aussiemark]

That's a good question the Challenger hood has openings that the scoops fit into and need the gaskets to seal but the Barracuda hood doesn't have any openings so maybe no gaskets?

 

[djais1801]

if you are talking about the "nostrils" there are no gaskets. It's just a housing with 2 holes per side, and the finned "fake" vents have two screw holes that line up and take allen screws.

That's a good question the Challenger hood has openings that the scoops fit into and need the gaskets to seal but the Barracuda hood doesn't have any openings so maybe no gaskets?

 

[Claudia]

djais1801 - No, I am not talking about the finned insert that attaches to the actual scoop. I am talking about the mating surfaces between the actual hood and the scoop.

 

[moparleo]

No.

 

[djais1801]

my bad...

djais1801 - No, I am not talking about the finned insert that attaches to the actual scoop. I am talking about the mating surfaces between the actual hood and the scoop.

 

[moparleo]

Nostrils is correct, no gaskets. djais1801 was right.

 

[71Plym]

On my 71, there is a formed plastic gasket that goes between the sport hood and each hood scoop. I have not seen those gaskets repopped yet. Mine were a little brittle but was able to reuse them.