• Welcome to For E Bodies Only !

    We are a community of Plymouth Cuda and Dodge Challenger owners. Join now! Its Free!

SOLD Need new rod pin bushings (small end)

Status
Not open for further replies.

mayhem

Well-Known Member
Joined
May 21, 2021
Messages
124
Reaction score
37
Location
Pacific NW
Rating - 0%
0   0   0
Contact seller
Need a set of 8 new pin bushings for a set of Manley rods. Ideally they would be part #42047-8 but Manley isn't producing these at this time and the rods are holding up the folks at the machine shop. Bushings are 1.154 od (but could be bigger & turned down), 1.031 id (but could be smaller & bored out), 1.250 wide. Engine shop guy said he spent an hour on the internet looking without luck. Where to look? Any help would be greatly apperciated. Thanks!
 
Found some. Not perfect sizes but Crower has some (90980X120-8). Summit sells them for $155 but Crower sells direct for $109.57 The machine shop says they will adjust the OD & ID and the slightly narrower width won't be a problem.
 
Status
Not open for further replies.
Back
Top