SOLD Need new rod pin bushings (small end)

[mayhem]

Need a set of 8 new pin bushings for a set of Manley rods. Ideally they would be part #42047-8 but Manley isn't producing these at this time and the rods are holding up the folks at the machine shop. Bushings are 1.154 od (but could be bigger & turned down), 1.031 id (but could be smaller & bored out), 1.250 wide. Engine shop guy said he spent an hour on the internet looking without luck. Where to look? Any help would be greatly apperciated. Thanks!

 

[TomIGo]

Good morning Mayhem! You may want to move this question to the Engine Issues forum for folks who monitor that forum! Link to Engine Issues forum

And maybe put a copy in the Wanted to Buy Forum. WTB Forum link

 

[mayhem]

Good morning Mayhem! You may want to move this question to the Engine Issues forum for folks who monitor that forum! Link to Engine Issues forum

And maybe put a copy in the Wanted to Buy Forum. WTB Forum link

Thanks for the response. I thought I put this in the Cars/Parts wanted? I'll check.

Mopar to ya!

 

[mayhem]

Found some. Not perfect sizes but Crower has some (90980X120-8). Summit sells them for $155 but Crower sells direct for $109.57 The machine shop says they will adjust the OD & ID and the slightly narrower width won't be a problem.