I am debugging my harness that has some non-operating lights. One of the lights not working was the glove box, even with a new bulb, while the adjoining map light was working. I wanted to check wire continuity so I tried to unplug it from the common point. Even using a set of long nose pliers and working the connector back and forth, unfortunately for me the end broke off. (Once I had the wire off the harness I did confirm the switch/light isn't the problem, it's somewhere else.)
I can't seem to find a source for the male connector on the end of the wire that I broke off. I need help sourcing it whether it is specific to Mopar or some generic connector that you experts will know of. Attached is a picture of a glove box light/switch out of a car (one for sale on ebay) that I am attaching because it shows the male "barrel" connector on the end of it that I am looking for. Just to be clear, I'm only looking for a replacement connector that I can crimp or solder on as appropriate, not the whole thing.
I can't seem to find a source for the male connector on the end of the wire that I broke off. I need help sourcing it whether it is specific to Mopar or some generic connector that you experts will know of. Attached is a picture of a glove box light/switch out of a car (one for sale on ebay) that I am attaching because it shows the male "barrel" connector on the end of it that I am looking for. Just to be clear, I'm only looking for a replacement connector that I can crimp or solder on as appropriate, not the whole thing.