DetMatt1
Well-Known Member
I don’t know.Standard or Ralley?
I don’t know.Standard or Ralley?
But my best guess is that it’s standard.I don’t know.
Nope.Do you happen to have a 73 challenger rallye under dash harness?
Still have a fuse block? If so, how much?I’ll do my best to Identify each of them if I can.
Starting with this one.
Part #3588291 1972-74 Challenger taillight harness.
Could be Barracuda too but I’m not sure.
Only 1 wire that ends abruptly, see pics for overall condition.
Asking $25 + shipping from the Detroit area.
I’ll call this one “1”.
This one is sold.
DO YOU HAVE DASH HARNESS BULKHEAD BLOCK 74 CUDA/CHALLENGER
Hey guys, here’s how this thread works. Everything I have is pictured and numbered and I did that so I didn’t have to rifle through a pallet of used wiring with every request. If you look through the whole thread you will see everything I have as well as which ones have sold.Still have a fuse block? If so, how much?
The one loose fuse block I have is not E-body so you’ll have to pick one of the harnesses in this thread that includes a fuse block.Still have a fuse block? If so, how much?
I will be at the swap meet selling stuff. I’ll check my stash tomorrow.Matt, I know this thread is E body centric, and not to hijack it, but... might you have a 69 B Body non rally dash harness, specifically the map light harness or even just the socket and pigtail? I have the bezel and switch. If so, will you be at the WPC meet on Sunday? Since I'm local, I'll stop by and say hello and pick through whatever you have. Thanks! DaveView attachment 67752
I would but I don’t remember off the top of my head. Against the East wall, south of center a bit. I’ll get back to you on that after I verify wether or not I have the part.Thanks Matt! Having not met you before, can you tell me your table #?
Unfortunately I just can’t find any spares in my stash. I know that all of the wiring in this thread isn’t E-body, most but not all so if you have time to scan through all the pics to see if you find something that works and then let me know.Thanks Matt! Having not met you before, can you tell me your table #?