What intake + carb will clear my R/T hood

[rbbruno3]

I was just talking with an engine builder about what intake to use without any hood mods. He said to measure The stock one and go from there. I was wondering what anyone else may have used with or without problems. Single plane dual plane/ Holley Demon. It is going to be a street car so I don't need the power band in the 5K range . Oh its a 440 40 over with a 4spd. Thanks

 

[Chryco Psycho]

The Holley Street Dominator intake is one of the best & sits as low any any performance intake . I typically use this on most builds .

 

[rbbruno3]

The Holley Street Dominator intake is one of the best & sits as low any any performance intake . I typically use this on most builds .

Ok, sounds good.

Thanks, Rick

 

[Brads70]

I'm using the Holley street dominator as Neil said and it does clear but I'm using a T/A hood?

 

[rbbruno3]

I'm using the Holley street dominator as Neil said and it does clear but I'm using a T/A hood?

I saw that on another thread. That looks nice Brad. I think I'll use that SD intake, not sure on carb or A/C. Thanks