OK so I am almost ready for paint and noticed that I forgot the roof drip rails. dug out the stuff filling them in found no holes or rust just tiny pin holes. so my question is since I am going back to the vinyl top what should I use to replace the stuff I took out ? it was old and brittle and...
Finally figured it out. the bottom of the hinge where the slider slides was badly worn after years of use had to bend the lower edge to keep it from popping off. THANKS for all the input and help.
Hi guys, I have a 73 challenger and every time I open the trunk if I do not hold the lid one of the plastic sliders pops off the hinge along with the spring, and I have to redo the whole spring conglomeration to replace it I have replaced the sliders with new ones, I am using the last slot for...
Thanks. My next thought was to change the tank and filler neck to an earlier model and just vent the tube out the trunk floor. the intake has been changed and there is no canister either.
I finally reached the interior of my 73 challenger I want to go with a tilt column p/s. Auto. floor shift. any ideas ? do I also need a joint or adapter to match the steering box as most columns that I have seen have a double d configuration ?
THANK YOU. I have no holes as I have a replacement qtr. plus I did not take the car apart. so I was just a little confused . better to ask than blindly go and just start drilling.
Ok so maybe I am dumb... but when replacing my filler neck does it go thru the outside of the quarter panel then thru the trunk to the tank or does it go to the inside of the quarter panel thru the trunk floor to the tank ? 73 challenger