Anyone know of a Kansas City area swap mopar swap meet or show? Just moved to the area and would like to get a few peices sold and bought for my project.
I spent $15,000 for body and paint work this winter for my car. The good painters here in Indianapolis are backed up for several years. It took me a year to get my car in and over 6 months to get it back. I spent an extra $10,000 to have metal repaired and replaced, and to have gaps and lines...
Is there supposed to be a washer included with these clips? Mine did not come with them. does the washer go under the nut or between the clip and the outside car surface?
I verified that i was at correct TDC, by looking through the exhaust port. When i turn the engine crankshaft about 90 degrees past TDC, the exhaust valve starts to open. I have the balancer mark right at the mark, and the distributor rotor pointing right at No. 1 cylinder.
Are these positions...
If i remember right from when i did mine, i was able to wrap enough material around, and cover The drip rail. The molding then goes over the top of the material.
I pulled it apart to see why the spring looks cockeyed. The flat surface that bolts o the pump is at an angle, and that is why the spring looks sideways. Small spring sits in the bottom, then a plunger/valve body, and then a long spring, and finally the cap bolt.
that is why i was wondering if...
Does the flow return/hose barb attachment to the steering gear box have a steel ball check valve that seats under the spring? This is a firm fell rebuild, and i was wondering, because from the picture, it looks a little odd.
Anyone know where i can find the two torsion rods used to open/tension for the challenger trunk lid? I am not certain if they are reproduced. I have never found them on ay site.
I originally used measurements from someone on a different site. Several holes were way off. I figured out i had to lay my trim on the car, tape it down in the best position possible and draw along the edges onto the car. I was able to get my holes better placed, but had to weld in several...
I bought a Dyancorn hood latch and bracket off of eBay, at the time i could not find an original used. I was able to get the brace/brackets to fit with a little massaging, but i can not get the latch assembly to work. I have twisted, adjusted and tweaked every which way i can. It just wont...