1970-74 Cuda door/window disassembly procedure needed

[kodiac]

Since I’m going to do a color change on the car, I need to remove the glass out my 1973 Cuda doors. I’ve checked YouTube for any videos that could give me a good step by step guide to get this done. Haven’t found one yet. Not a hard job but it helps to ask questions first to sidestep any potential glass shattering issues.
I searched this site and didn’t find it. Can anyone point me in the right direction?

 

[pschlosser]

DO seek out a factory service manual, for any of the 1970-74 years, as the procedure will be more or less the same.

Unless you force or pound on something, broken glass is unlikely.

While it may be an easy job, I don't recall ever finding or following a procedure. But I can add this:

taking the window glass out, and R&Ring the window track and regulator, is among the most frustrating things I have done on my car. I recall my forearms and fingers getting cut up (by the openings in the door) in the process. This may be the task I detest the most on these cars.

 

[moparleo]

Factory Service Manual is a must for any car.

 

[Xcudame]

Instead of taking the door glass out, I'd spray the glass with WD40 and just roll them down when painting! Then clean them up with Windex. Like @pschlosser said, too many cuts and scraps to R&R the window glass if you don't have too! Heck, don't put anything on the glass, roll them down, paint and roll them back up and remove any over spray with a rag wet with Acetone (wear thick rubber gloves)!

 

[Challenger RTA]

Service manual a good thing to have. Click here. Service manual