Need carb part ID

[Stev-o]

Reinstalled an Edlebrock carb on a '72 Charger 440 and broke the little clip at the end of the accelerator cable, one in pic is very similar. The clip slips on the ball end of the accelerator and then slides onto a small shaft on the carb throttle and is secured with a cotter pin. I've searched online and cannot find this particular clip.
Please help. Thanks

 

[Stev-o]

Really, no one can help?!!

 

[Xcudame]

@Stev-o, I just got to the site today. Try your nearest AutoZone in the Dorman help section.

Dorman - HELP 1/8in to 1/4in Universal Hair Pin Clip Assortment 6 Pack

Shop for Dorman - HELP 1/8in to 1/4in Universal Hair Pin Clip Assortment 6 Pack with confidence at AutoZone.com. Parts are just part of what we do. Get yours online today and pick up in store.

www.autozone.com

 

[Challenger RTA]

Really, no one can help?!!

Just now seen you help wanted too. Don't know how it got missed by everyone. Maybe July 1st was to close to the 4th? Bad timing? Off 3 deg day.

 

[Jeff K]

Stev-O, if I'm reading your post correctly, you're looking for the U-shaped clip at the left end of the cable shown in the pic below. Is that correct?

Assuming you locate one, how would you install the new clip on the old cable? You would have to remove the ball end from the old cable, slip the new clip on the cable, then swage a new ball back on the end of the cable. Have you got the tool to do that with?

As to your question, I don't know where you'd locate just the clip.

I think you'd be better off buying a new accelerator cable.

 

[moparlee]

@Stev-o, I just got to the site today. Try your nearest AutoZone in the Dorman help section.

http://[URL]https://www.autozone.co..._0LjNfOt_bckhoCnRcQAvD_BwE&new_store_set=true

[/URL]

I think he is looking for the U shaped clevis clip on the end of the cable.

 

[Xcudame]

Then he needs a new cable, unfortunately.

 

[Stev-o]

Stev-O, if I'm reading your post correctly, you're looking for the U-shaped clip at the left end of the cable shown in the pic below. Is that correct?

Assuming you locate one, how would you install the new clip on the old cable? You would have to remove the ball end from the old cable, slip the new clip on the cable, then swage a new ball back on the end of the cable. Have you got the tool to do that with?

As to your question, I don't know where you'd locate just the clip.

I think you'd be better off buying a new accelerator cable.

View attachment 142681

Hi...yes, need just the clip as it literally broke in half when I was trying to reinstall. The U-shaped clip just slips onto the cable, the notch is not visible in the pic above. I dont have a problem buying a cable as long as the clip comes with, the cables online that I saw did not show it. Where is the pic you posted from? Thank you for your help.

 

[Jeff K]

Year One sells them, I suspect others do as well. Measure your old one before you order, make sure you're getting the same cable.

https://www.yearone.com/Product/chrysler-b-body/ac774#prettyPhoto

 

[Stev-o]

Year One sells them, I suspect others do as well. Measure your old one before you order, make sure you're getting the same cable.

Thank you, cable ordered.