need help again

[olebrowndodge]

ok igot everything under the front of my 73 barracuda replaced, now have the engine and tranny in also, i havent tighten the lower control arms and strut rod bars all the way up yet , my question is do i put it on the ground and tighten everything up and then adjust ride height or is there something else i need to do? thanks

 

[MOPARMITCH]

You should allow it to settle on the ground, and roll it back and forth a few feet. set torsion bar height.Then tighten lower and upper control arms and strut rods. Set torsion bar again if needed, then and recheck height after roll.

 

[olebrowndodge]

ok, thanks for the help , thats whats good about these sites getting advise and help

 

[mmissile]

You'll going to wanna look at the ride height after it's driven a bit. I've had some settle considerably.

 

[olebrowndodge]

ok thanks good to know

 

[moparleo]

After you get her running, get her over to a good alignment shop before you scrub the tires.

 

[djais1801]

and put some pics up of your fish!

 

[olebrowndodge]

ok , thanks again everyone and thanks to e-bodies for this site it is very helpful